AMX manual Installing an MVP-BP Battery into an MVP-TDS

Page 13

MVP-TDS Table Top Docking Station

Installing an MVP-BP Battery into an MVP-TDS

The MVP-TDS connects directly to a PSN4.4 power supply and provides both power and communication to docked MVP panel. The MVP-TDS can charge batteries in its own battery compartments, as well as those within the MVP panel.

1.Raise the rear connector cover to expose the battery compartments and connectors.

2.Slide the MVP-BP into the battery compartment (AMX label up) until the connector makes contact with the battery pins at the end of the battery slot.

3.Repeat these steps for any additional MVP-BP batteries.

4.The status of the connected batteries are reflected on the panel’s Batteries page and the LEDs on the docking station.

A completely discharged battery requires one full charge cycle from within battery compartment #1. Refer to FIG. 2 on page 2 for locations.

MVP-TDS Table Docking Station for MVP Panels

7

 

 

Page 12 Page 14
Image 13
Page 12 Page 14
Contents MVP-TDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page Overview SpecificationsFront Panel Components MVP-TDS docking station connectorsConnecting a Power Supply InstallationMVP-TDS LED Indicators Interface Connector Pins and FunctionsAfter the panel splash-screen disappears Connecting a USB Keyboard and Mouse to the MVP-TDSSystem message panel is properly docked Securing an MVP Panel to an MVP-TDSRemoving an MVP Panel from an MVP-TDS Installing and Charging Batteries in the Docking StationsUnsecured MVP removal from an MVP-TDS Secured MVP removal from an MVP-TDSInstalling an MVP-BP Battery into an MVP-TDS Page Prepare the Docking Station for firmware transfer via USB Upgrading the Docking Station FirmwareBatteries Upgrade the Docking Station firmware via USBDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control
Top Page Image Contents