Charging

–Turn off the iM510 and disconnect the power supply.

–Use a USB cable (not included) to connect the iM510 to your computer.

Note: After syncing the Sansa player to your computer, be sure to disconnect the USB cable before reconnecting the power supply or turning the iM510 on.

The inMotion iM510 can double as a charging station for your Sansa player. To charge your Sansa player using the inMotion iM510, follow the steps below:

–Make sure the iM510 is not connected to a USB cable.

–Connect the iM510 to a wall outlet using the power supply.

–Connect the Sansa player to the inMotion iM510 by plugging the docking bay connector into the Sansa player port.

CONNECTING TO ALTERNATE AUDIO SOURCE

The inMotion iM510 system includes an auxiliary input jack that allows you to connect to alternate audio sources, such as non-dockable MP3 players, CD players, portable DVD players, and laptops. To connect the iM510 to an alternate audio source, follow the steps below.

1.Connect one end of the 3.5 mm stereo cable into the auxiliary input jack (AUX) located on the back of the inMotion iM510 system, and the other end to the headphone or line out jack on your alternate audio device.

2.Set the volume on the audio source at mid-level.

3.Set the volume on the inMotion iM510 at minimum level and adjust upward to a comfortable listening level.

VOLUME

The “+” and “–“ buttons on the top of the inMotion iM510 are the master volume controls. Press and hold the “+” button to increase the volume and the “–“ button to decrease the volume.

FOR ADDITIONAL BASS

The inMotion iM510 is equipped with a subwoofer jack (“SUB OUT”). This output should only be used to connect an Altec Lansing optional subwoofer specifically designed to increase the bass output of this speaker system. Please check www.alteclansing.com/bb2001 for availability information.

TROUBLESHOOTING

SYMPTOM	POSSIBLE PROBLEM	SOLUTION

No Power	The power supply cord isn’t	Insert the barrel connector from the power supply
LED is	connected to a wall outlet and/or	into the DC connector on the back of the
lit (AC	the power supply connector is not	inMotion iM510. After this connection is made,
Operation).	plugged into the power supply jack	insert the power supply into a wall outlet.
	on the back of the inMotion iM510.

	The surge protector (if used) isn’t	If the power supply cord is plugged into a surge
	powered on.	protector, make sure the surge protector is
		switched on.

	The wall outlet is not functioning.	Plug another device into the same wall outlet to
		confirm the outlet is working.

	The power isn’t turned on.	Turn on the inMotion iM510 by pushing the
		power button located on the top of the unit. A
		blue LED will light around the button when the
		power is on.