Rear Panel
1 |
2 |
3 |
4 |
5 |
6 |
1.Cooling Fan
•The fan always turns when the power is on. Provide a minimum of 6 inches (15 cm) of clear space on all sides of the fan when you install the product.
2.2.0 CH Speaker Connector Terminals
The speaker connector terminals are located on the rear of the system.
1.To achieve the correct sound quality, insert the speaker connector cables identified below into the correct speaker terminals on the back of the system.
•Left speaker (marked L).
•Right speaker (marked R).
3.ONLY FOR SERVICE
•This jack is for service only. Please do not use.
4.AUX IN 2 Terminals
1.Use an Audio Cable (not supplied) to connect AUX IN 2 on the product to Audio Out on an external analog component.
•Be sure to match connector colors.
•If the external analog component has only one Audio Out jack, connect to either the left or right terminal.
•Press the TUNER/AUX button to select the AUX 2 input.
•When the unit is in AUX mode, if none of the buttons are pushed for more than 8 hours, the power will automatically turn off.
5.FM Antenna Connector Terminal
1.Connect the FM antenna (supplied) to the FM Antenna jack.
2.Slowly move the antenna wire until you find a location where reception is good, then fasten it to a wall or other rigid surface.
3.If reception is poor, you may need to install an outdoor antenna. To do so, connect an outdoor FM antenna to FM antenna jack on the rear of the system using a 75Ω coaxial cable (not supplied).
6.LED Terminals for the Front Speakers
To enjoy the special light effect of the speakers, connect the LED cables of the Front Speakers to the LED terminals of the system.