Cambridge SoundWorks II Setup Options, Desktop Placement, Wall Mounting With Supplied Hardware

SETUP OPTIONS

Cambridge SoundWorks, Inc. supplies screws and plastic anchors for convenience, but it is the speaker purchaser’s responsibility to insure that any speaker mounting or placement is secure, stable and reliable. Cambridge SoundWorks assumes no responsibility for damage to its products or any damage to property resulting from speaker positioning or placement.

SUBWOOFER/AMPLIFIER

The Subwoofer/Amplifier requires no assembly.

SATELLITES

Desktop Placement

Each satellite is shipped with a Desktop Stand installed. You can also mount the Volume Control to a Desktop Stand (see page 12).

Shelf Placement (or other flat surface) without the

Desktop Stand

A)Desktop Stand Removal: unscrew the thumbscrew to release the satellite.

B)Apply the soft, self-adhesive feet to the bottom surface of each satellite, as shown.

Wall Mounting With Supplied Hardware

Note: Use the “hook and loop” fastener to secure the

volume control to a convenient flat surface if not using the

Desktop Stand

C)Apply the soft, self-adhesive feet to the back of the satellite as shown. The feet provide mounting stability and protect the finish of both the wall and the satellite.

D)Install the No.10 screw and anchor in the wall so that its screwhead protrudes about 3/8 inch.

E)Adjust the screw so each satellite can be hung with just a small amount of pressure.

A

B

Apply Feet to

Bottom for Flat

Surfaces

C

Apply Feet to Back for Wall Mounting on Screwhead

D

Install

E

Mount Speaker

6