a/d/s/ PH30.2 manual Speaker connections for stereo configurations

Page 14

Connect to 12V turn-on lead from source unit

70A

fuse

Connect to chassis of vehicle

Factory chassis ground

Connect to chassis of vehicle

70 Amp fuse

less than 18" from battery

speaker connections for stereo configurations

Minimum recommended impedance is 2 stereo. Speaker terminals accept up to AWG #12 speaker wire.

70A

speaker connections for bridged configurations

Minimum recommended impedance is 4 when bridged to subwoofers and 4 when bridged to full range speakers. Speaker terminals accept up to AWG #12 speaker wire.

70A

13

Image 14

Contents PH30.2 Table of contents IntroductionKeep listening, but be safe Features of your PowerPlateAbout this manual Trunk compartment mounting Mounting locationsPassenger compartment mounting Engine compartment mountingSystem planning Speaker requirementsSystem configurations 70A Left tweeter Right tweeter Left midrange Right midrange Subwoofer Right satellite Left satellite Subwoofer Page Amplifier and crossover controls Controls and connections InstallationPower connections Speaker connections for stereo configurations Speaker connections for bridged configurationsSignal sources Pin Wire ColorInternal signal routing Multi-cross crossover configuration Digital crossover frequency displayTuning the crossover Using the AC502 optionalTuning Constant Bass circuitAdjusting input sensitivity Audio cycles on and off TroubleshootingNo output Distorted outputPoor bass response Battery fuse blowingDistorted output cont’d Amplifier fuse blowingSpecifications Amplifier sectionWarranty information Limited TWO Year Consumer WarrantyDirected Electronics, Inc. All rights reserved G49200