a/d/s/ PH30.2 manual 70A

Page 7

System 2 - PH30.2 used in 5-channel mode with the AC502 providing level control for bridged channels 5 and 6. 1 and 2 are high-passed for front speaker and channels 3 and 4 are high-passed for rear speakers. Although shown as a 4-channel input, the source unit can be either 2 or 4-channel depending on the setting of the 2/4 channel switch.

70A

front left satellite

front right satellite

rear left satellite

rear right satellite

subwoofer

System 3 - PH30.2 used in 6-channel mode with source unit providing direct level control for channels 5 and 6 through the fade control. Channels 1 and 2 are configured high-pass for tweeters, channels 3 and 4 are configured bandpass for midrange and channels 5 and 6 are configured low-pass for subwoofers.

70A

left tweeter

right tweeter

left midrange

subwoofer

right midrange

subwoofer

6

Image 7
Contents PH30.2 Introduction Table of contentsAbout this manual Features of your PowerPlateKeep listening, but be safe Engine compartment mounting Mounting locationsPassenger compartment mounting Trunk compartment mountingSpeaker requirements System planningSystem configurations 70A Left tweeter Right tweeter Left midrange Right midrange Subwoofer Right satellite Left satellite Subwoofer Page Amplifier and crossover controls Power connections InstallationControls and connections Speaker connections for bridged configurations Speaker connections for stereo configurationsPin Wire Color Signal sourcesInternal signal routing Digital crossover frequency display Multi-cross crossover configurationConstant Bass circuit Using the AC502 optionalTuning Tuning the crossoverAdjusting input sensitivity Distorted output TroubleshootingNo output Audio cycles on and offAmplifier fuse blowing Battery fuse blowingDistorted output cont’d Poor bass responseAmplifier section SpecificationsLimited TWO Year Consumer Warranty Warranty informationDirected Electronics, Inc. All rights reserved G49200