Frequently Asked Questions
How do I clean my speakers?
Use a dust free cloth or a soft brush to remove the dust from your speakers. We also recommend a specialty cloth (available at the Xtatic shop at www.martinlogan. com) that cleans your speakers better than anything else we have tried. For the wood surfaces it is accept- able to slightly dampen the cloth. Do not spray any kind of cleaning agent on or in close proximity to the electrostatic element.. Avoid the use of ammonia based products or silicone oil on the wood parts..
What is the advantage of ESL?
Since the diaphragm is uniformly driven over its entire
What size amplifier should I use?
We recommend an amplifier with 100 to 200 watts per channel for most applications. Probably less would be adequate for our smaller hybrids or when used in home theater where a subwoofer is employed. Our hybrid designs will perform well with either a tube or transistorized amplifier, and will reveal the sonic char- acter of either type. However, it is important that the amplifier be stable operating into varying impedance loads: an ideally stable amplifier will typically be able to deliver nearly twice its rated wattage into 4 Ohms and should again increase into 2 Ohms.
Could you suggest a list of suitable electronics and cables that would be ideal for MartinLogan speakers?
The area of electronics and cable choice is probably the most common type of question that we receive. It is also the most subjective. We have repeatedly found that brands that work well in one setup will drive someone else nuts in another. We use many brands with great success. Again, we have no favorites; we use electronics and cables quite interchangeably. We would suggest listening to a number of
Is there likely to be any interaction between my speakers and the television in my Audio/Video system?
Actually, there is less interaction between a television and an electrostatic speaker than between a television and a conventional system. However, we do recommend that you keep your speakers at least one foot away from the television because of the dynamic woofer they employ. In the case of our center channel speakers, however, they are fully shielded and can go anywhere.
Will my electric bill go ‘sky high’ by leaving my speak- ers plugged in all the time?
No. A pair of MartinLogan’s will draw approximately 1 watt maximum (in standby mode). There is circuitry to turn off the static charge when not in use; however, actual consumption will remain close to the same. The primary purpose of the sensing circuitry is to prevent dust collection on the electrostatic element.
If the diaphragm is punctured with a pencil or similar item, how extensive would the damage to the speaker be?
Our research department has literally punctured hundreds of holes in a diaphragm, neither affecting the quality of the sound nor causing the diaphragm to rip. However, you will be able to see the actual puncture and it can be a physical nuisance. If this is the case, replacing the electrostatic transducer will be the only solution.
Will exposure to sunlight affect the life or performance of my speakers?
We recommend that you not place any loudspeaker in direct sunlight. The ultraviolet (UV) rays from the sun can cause deterioration of grill cloth, speaker cones, etc. Small exposures to UV will not cause a problem. In general, the filtering of UV rays through glass will greatly reduce the negative effects on the electrostatic membrane itself.