The Summi X’s feet can be configured to adjust the rake of the speaker from
Spike Installation Instructions:
1Carefully lay your speaker on its side.
2Remove existing feet. Thread the spikes into the holes and screw them in all of the way. If the speaker does not sit level loosen one spike until level is achieved.
3Tighten the jam nut snugly by hand. Do not over tighten.
4Right the speaker.
Caution: Make sure your hands and any cabling are clear of the spikes. Do not slide speaker as spikes are sharp and can damage your floor or carpet.
5Adjust to level by rotating spikes. Tighten the jam nut securely when satisfied that speaker is level.
A 11° D | B | 9° | D | A | 7° | B | D | 5° | C | B | 3° | A | D | 1° | B | D |
|
|
|
| A |
|
| B |
|
| C |
| D |
|
|
|
|