Gate Threshold - The Number 4 Knob sets the signal strength required to open or close the Noise Gate. The Gate Threshold parameter ranges from 1 (opens easily) to 40 (requires strong signals to open).
Pluck Sensitivity - The Number 5 Knob controls the point where the Gate
Mod Effects
The Modulation Effects row in the RP300A is a
Chorus (CHORUS)
A Chorus adds a short delay to your signal. The delayed signal is modulated in and out of tune and then mixed back with the original signal to create a thicker sound.
Parameter 1 - The Number 2 Knob adjusts the rate (Speed) of the modulation. Ranges from 1 to 99.
Parameter 2 - The Number 3 Knob adjusts the intensity (Depth) of the modulation. Ranges from 1 to 99.
Mod Level - The Number 5 Knob controls the volume of the Chorus. Ranges from 0 to 99.
The Number 4 Knob has no function when the Chorus is selected.
Flange (FLaNge)
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds regeneration (or repeats) to the modulating delay. This results in an exaggerated up and down sweeping motion to the effect.
Parameter 1 - The Number 2 Knob adjusts the rate (Speed) of the modulation. Ranges from 1 to 99.
Parameter 2 - The Number 3 Knob adjusts the intensity (Depth) of the Modulation. Ranges from 1 to 99.
Parameter 3 - The Number 4 Knob adjusts the amount of regeneration (repeats) added to the Flanger delay. Ranges from 1 to 99.
Mod Level - The Number 5 Knob controls the mix of wet and dry signal. Ranges from 0 (all dry) to 99 (all wet).
Triggered Flanger (TRGFLG)
A Triggered Flanger is the same sound as a regular Flanger but allows you to choose the starting point of the Flanger sweep. In a regular Flanger, the low frequency oscillator (LFO) is continually sweeping up and down. This means that when you begin to play, the flanger may be at the top, bottom, or any random point of the sweep. With a Triggered Flanger, every time the signal exceeds the Sensitivity level setting, the Flanger will begin at the point of the sweep that you designate with the value of the LFO Start Parameter.
Parameter 1 - The Number 2 Knob adjusts the rate (Speed) of the modulation. Ranges from 1 to 99.
13