DigiTech RP300A manual Applying Power

Page 9

Applying Power

Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the steps listed below.

1.Turn the amp volume all the way down.

2.Connect the plug of the PS0913B power supply to the Power Jack on the rear panel of the RP300A.

3.Connect the other end of the PS0913B power supply to an AC outlet and turn the Master Level knob until the display reads mlevel o.

4.Turn the power of your amplifier(s) to the on position and adjust the volume(s)to a normal playing level.

5.Gradually increase the RP300A’s Master Level to achieve the desired volume.

Image 9

Contents User’s Guide Important Safety Information Declaration of Conformity Warranty RP300A PS0913B Power Supply Warranty Card Getting AcquaintedIncluded Items RHYTHM30 Guided Tour of the RP300AFront Panel Rear Panel Getting Started Making Connections Mono OperationStereo Operation Applying Power Performance Mode PresetsBypass Mode Tuner ModeUsing Learn-A-Lick Learn-A-Lick ModeJam-A-Long Drum MachineEditing/Creating Presets Section Two Editing FunctionsMatrix Store Storing/Copying/Naming a PresetAbout the Effects Section Three Effects and ParametersEffect Definitions Pickup/WahAmp Modeling/Cab CompressorNoise Gate Chorus Chorus Flange FLaNgeTriggered Flanger Trgflg Triggered Phaser Trgpha Phaser PHaseRTremolo Tremlo Panner PannerVibrato viBRTO Parameter 1 The Number 2 Knob adjusts the PedalRotary Speaker Rotary YaYa yayaEnvelope Filter eNvlOp SynthTalk syNtLKDetune DetUNe Pitch Shift PitCH1OCTUP 1 octave above Whammy no Dry Signal Harmony Bends Dry Signal Added2OCTUP 2 octaves above ActionExpression Pedal Section Four Other FunctionsLFO SwitchExpression Pedal Calibration Factory ResetSwitch Sensitivity Section Five Appendix Factory Preset ListPower Consumption 10 Watts Memory 40 User SpecificationsInput 1/4 TS Drum Machine 30 Patterns Simultaneous Effects up to