Amphion M510 Handling precautions, If the Surface is soiled, Improper disc storage, Maintenance

Page 5

the DVD-Player from the system unit and refer servicing to qualified service personnel under the following conditions:

1.When the power cord or plug is damaged or frayed.

2.If liquid have been spilled onto the DVD-Player.

3.If the DVD-Player has been exposed to rain or moisture.

4.If the DVD-Player does not operate normally after you have followed the operating instructions. Adjust only those controls covered by the operating instructions; improper adjustments to other controls may result in damage and may require extensive work by a qualified technician to restore the DVD-Player to normal operation.

5.If the DVD-Player has been dropped or the cabinet has been damaged.

6.When the video and audio of DVD-Player exhibits a distinct change in performance.

7.To reduce the risk of electric shock, do not remove the cover (front or back). No user-serviceable parts inside. Refer servicing to qualified service professional.

8.This produ ct applies to U.S. Pat ent Nos. 4,631,603, 4,577,216, 4,819,098 and 4,907,093 Licensed for limited viewing uses only.

9.DVD-Player is a high quality laser product. This player uses a visible laser beam that could cause hazardous radiation exposure if directed to the eyes.

Notes on Discs

Handling precautions

Hold the disc by the edges so the surface will not be soiled with fingerprints. Fingerprints, dirt and scratches can cause skipping and distortion.

Do not write on the label side with a ball-point pen or other writing tools.

Do not use record cleaning sprays, benzene, thinner, static electricity prevention liquids or any other solvent.

Be careful not to drop or bend the disc.

Do not install more than 1 disc on the disc tray.

Do not try to close the disc tray when the disc is not installed properly. Be sure to store the disc in its exclusive case.

If the Surface is soiled

Wipe gently with a soft, damp (water only) cloth.

When wiping discs, always move the cloth from the center hole toward the outer edge.

If you wipe the discs using a circular motion, circular scratches are likely to occur, which will cause noise while playing.

If the disc is brought from cold to warm environment, moisture may form on the disc. Wipe this moisture off with a soft, dry, lint-free cloth before using the disc.

Improper disc storage

You can damage discs if you store them in the following places:

Areas exposed to direct sunlight.

Humid or dusty areas.

Areas directly exposed to a heat outlet or heating appliance.

The player can not play discs

DVD region code is not suitable for your player.

Maintenance

Be sure to turn the power button OFF and disconnect the power plug before maintaining the unit.

Wipe this unit with a dry soft cloth.

If the surface is extremely dirty, wipe clean with a cloth that has been dipped in a weak acid and water solution and wrung out thoroughly, and then wipe again with a dry cloth.

Never use alcohol, benzene, thinner, cleaning fluid or other chemicals. And do not use compressed air to remove dust.

4

Image 5
Contents M510 Before Using this Player Power Cord Warnings Important Safety Instructions Maintenance Handling precautionsIf the Surface is soiled Improper disc storageTable of Contents Video CD Accessory ListM510 Quick User Guide Connecting the PowerOpening the LCD screen Opening the Disc CoverTurning the power OFF Turning the power onPlacing a Disc Playing a DiscParts and controls PreparationsButton-type battery Lithium battery Remote controlUsing the battery pack IndicatorsUsing the car adapter Connecting the battery pack to the unit Duration to Recharge the Battery Recharge timePlaying back When the menu screen is displayedPress Open to open the display Panel Unit and open the disc coverRemoving the disc To turn the power offPress Display Mode on the unit Display mode on the liquid crystal displayTo clear the resumed point Full NormalPress four times to enter the Phase function Detailed Description of each OSD Menu Icon Operation with OSDInformation about On Screen Display OSD Changing Subtitle Language Using a Title / DVD MenuPress or to select the Preference Changing Audio Soundtrack LanguageViewing from another Angle Repeat viewing listening Press Repeat during playback Repeat PlayRepeating viewinglistening Press Repeat during playback Pressed, repeat options are shown as followsPlayback with MP3 Zoom FeatureProgram Play What is DVD-Audio What is WMAWhat is JPEG? Playing Your Jpeg Files Playing Your Jpeg FilesChanging setup values Initial SettingsSpeaker Setup Downmix Speaker Setup Spdif Setup Dolby Digital SetupPost Drc PCM ChannelVideo Setup Equalizer 3D Processing Video Setup EQ TypeBass Boost Super BassLuma Delay Video Quality Setup SharpnessBrightness ContrastPreference TV Type DefaultAudio SubtitleExit Setup Exit Setup Menu Password Setup Password ModePassword Connection Connecting to a wide TV/ an AV TVConnecting to an active speaker system Connecting to an audio equipmentOutput sound from the optical output terminals of this unit Troubleshooting Language codes Remote control Remote control does not workExplanation of terms Others Chapter