Ericsson LBI-39175A manual Control Unit, Ege

LBI-39175A

		CONTROL UNIT
SYMPTOM		DIAGNOSTIC PROCEDURE
Radio dead at power-on	a.	Check the battery connections and the Red lead A+ fuse on the power
(display dark and no		cable.
lighted indicators)	b.	Turn the unit "OFF," then simultaneously press and hold the
		"EMERGENCY" and "OPTION" buttons, while turning the unit "ON."
		All indicator lights and all display dots should light. Release the buttons
		and the display should show the following message:
		© - 1993	or	© - 1994
		EGE		EGE
		This indicates the Control Unit is functioning correctly. If this passes,
		check programming and feature encryption, using "EDACS3" PC
		Programming utility.
	c.	If this fails, measure A+ voltage at MIC connector Pin 6 (referenced to
		ground at Pin 7). If this fails, check fuse F601 on the Logic PWB for A+
		on each side of the part. Replace the PWB if it is open circuited.
	d.	If the fuse is OK, check the connection of the Flex Circuit PC2 with J701
		on the Logic PWB. If this fails, reconnect PC2, making sure the side tabs
		are locked. Re-check the MIC connector Pin 6 for A+.
	e.	If this passes, check the programming and feature encryption, using
		"EDACS3" PC Programming utility. If this symptom persists, substitute a
		known good Logic PWB, and re-program.
	f.	If no A+ is present at MIC Pin 7, check for A+ on the Logic PWB J704 Pin
		3. If this fails, check the J704/J1004 connection. If this fails, replace the
		PA module. If this passes, replace the Logic PWB.
The Display lights, then	a.	Turn the unit "OFF," then simultaneously press and hold the
goes dead.		"EMERGENCY" and "OPTION" buttons, while turning the unit "ON."
		All the indicator lights and all display dots should light. Release the buttons
		and the display should show the following message:
		© - 1993	or	© - 1994
		EGE		EGE
		This indicates the Control Unit is functioning correctly. If this passes,
		check programming and feature encryption, using "EDACS3" PC
		Programming utility.
	b.	If this passes, check the connection of the Flex Circuit PC2 with J701 on
		the Logic PWB. If this passes re-connect it making sure the side tabs are
		locked.

18