Uniden uh078sx manual Battery Level Display

Page 9

Battery Level Display

The BATTERY icon in the top right hand corner of the screen indicates the uh078sx current battery voltage level at all times. The battery level is displayed in 4 levels.

LEVEL 4

Battery 100% full

LEVEL 3

Battery approx. 40% capacity

LEVEL 2

Low Battery

LEVEL 1 (flashing)

Empty Battery

When PTT is pressed at Level Empty, battery icon and channel number will flash, transmission is disabled.

Recharge the battery at any time. From empty the battery will take up to 5 hours to fully charge.

Battery Life :

15 Hours (Low Power), 14 Hours (Mid Power), 9 Hours (High Power)

This is based on the following Duty Cycle:

Transmit5%

Receive5%

Stand-by90%

7

Image 9
Contents Operating Guide Waterproof JIS7 Lithium ION Battery Pack WarningContents Introduction FeaturesIncluded in Your Package Optional Accessories Getting Started Connect Charger with AC adaptor Attaching the Antenna Attaching the Beltclip Attaching the Battery PackDo not transmit when the uh078sx is in the drop-in charger Charging the Battery PacksBattery Level Display Volume Power ON/OFFAdjusting the KEY Beeps OperationRoger Beep Selecting ChannelTransmitting a Call Tone Squelch To Transmit and Receive Using a Repeater Channel To Operate uh078sx in Duplex Mode ScanningExample CH40 becomes active Group Scan GS Mode Priority Channel DROP-OUT DelayProgramming Scan Channels Choosing a Priority ChannelManual Programming Receive ChannelsAdvanced Features Ctcss Continuous Tone Coded Squelch SystemDCS Digitally Coded Squelch To De-activate VOX To activate VOXPower Save Busy Channel LOCK-OUT BCL UHF Channel & Frequencies Ctcss & DCS Code List MENU/ENT Controls & IndicatorsLCD Display Uniden UH078SX UHF CB Transceiver Radio Warranty