Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the Remote Control Sender units, and in numeric sequence. Second install batteries into the Indoor Temperature Station. Transmission problems will arise if this is not done correctly and if the total time for
A. SET-UP OF MULTIPLE UNITS
1.It is necessary to remove the batteries from all units currently in operation.
2.Remove the battery covers to all Remote Control Sender units.
3.Place all Remote Control Sender units in a numeric sequential order.
4.In sequential order, install batteries (follow the same battery installation procedures seen in section I. A) of the Detailed
5.Install batteries into the Indoor Temperature Station.
6.Follow the Detailed
B.VIEWING AND OPERATING WITH MULTIPLE REMOTE CONTROL SENDER UNITS
1.To view the temperature of a different Remote Control Sender unit, press the CH button. A shift from one “boxed” number to the next should be observed in the OUTDOOR LCD.
2.To view the Minimum/Maximum temperature: first select which Remote Control Sender to read data from (indicated by the “boxed” number), then press the OUT button. Pressing this button once will display the minimum temperature, and the date and time the data was recorded. Pressing this button a second time (while “MIN” is still displayed, otherwise press the button twice) will display the same data for the maximum recordings.
3.To reset the Minimum/Maximum readings, it is necessary to select which Remote Control Sender you wish to reset. Press and hold the OUT button for 5 seconds, the records for the selected Remote Control Sender unit will be reset.
16