B. MOUNTING WITH ADHESIVE TAPE
1)With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat.
2)Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket.
3)Remove the protective strip from the other side of the tape. Position the Remote Control Sender in the desired location, ensuring that the Indoor Temperature Station can receive the signal.
II.THE INDOOR TEMPERATURE STATION
The Indoor Temperature Station can be mounted in two ways:
•with the table stand or,
•on the wall with the use of a wall hanging screw (not included).
A. USING THE TABLE STAND
1)The Indoor Temperature Station comes with the table stand already mounted. If you wish to use the table- stand all that is required is to place the Indoor Temperature Station in an appropriate location.
B. WALL MOUNTING
1)Remove the
2)Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall.
3)Place the Indoor Temperature Station onto the screw using the hanging hole on the backside. Gently pull the Station down to lock the screw into place.
18