La Crosse Technology WS-9210U instruction manual Indoor Weather Station

Page 6

DETAILED SET-UP GUIDE

I. BATTERY INSTALLATION

A. REMOTE TEMPERATURE SENSOR

1.Remove the mounting bracket. The bracket

snaps on and off easily.

2.Remove the battery cover, by sliding the cover down.

3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free).

4.Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

B. INDOOR WEATHER STATION

1.Remove the battery cover. To do this, insert a solid object in the space provided at the lower-central position of the battery cover, then push up and pull out on the battery cover.

2.Observe the correct polarity, and install 2 AA batteries.

3.Replace the battery cover.

Note: Immediately after the batteries have been installed, each LCD (Liquid Crystal Display) will flash and a tone will sound. Within a few seconds the indoor temperature will be displayed. If not, then remove the batteries for 10 seconds and reinstall. If the outdoor temperature is not displayed within four minutes, remove batteries from both units, wait 10 seconds, and reinstall. The time will show -:-- and start searching for the WWVB signal. If it successfully receives the time signal (usually at night), it will display the correct time (default is Eastern).

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents WS-9210U Contents Wireless Temperature Sensor Mounting Bracket Inventory of ContentsAbout Wwvb Radio Controlled Time Quick SET-UP Guide Do not Press ANY Buttons for 15 MinutesIndoor Weather Station Programming Sequence Program ModeIII or 24 Hour Time Setting II. Function KeysIV. Time Zone Setting Daylight Saving Time DST SettingWwvb Remote Control Time Manual Time SettingVI. Time VII. Setting the DAY, DATE, and Year IX. Setting the LCD Contrast VIII. Selecting F or CFeatures of the WS-9210U Indoor TemperatureII. Outdoor Temperature Viewing the Outdoor Temperature Records III. Minimum and Maximum Temperature RecordsViewing the Indoor Temperature Records Resetting the Mimimum and Maximum RecordsSnoozing and Stopping the Alarm IV. Alarm FunctionSetting the Alarm alarms 1 Adding Outdoor Remote Control Senders OptionalSET-UP of Multiple Units Mounting Remote Temperature Sensor Mounting with ScrewsMounting with Adhesive Tape II. the Indoor Temperature Station Using the Table StandWall Mounting Troubleshooting Maintenance and Care InstructionsPower Supply SpecificationsTemperature measuring range Dimensions H x W x DPage Support@lacrossetechnology.com
Top Page Image Contents