Mounting

5.Install batteries into the indoor weather station.

6.Follow the Detailed Set-Up Guide for programming and operating instructions.

B.VIEWING AND OPERATING WITH MULTIPLE REMOTE TEMPERATURE SENSOR UNITS

1.To view the temperature of a different remote temperature/humidity sensor unit, press and release the IN/OUT, SET/CH button. A shift from one “boxed” number to the next should be observed just below the temperature and humidity display.

2.To view the minimum/maximum temperature/humidity: first

select which remote temperature/humidity sensor to read data from (indicated by the “boxed” number), then follow the steps listed on page 14 – 15 in the “Viewing The Outdoor Temperature/Humidity Records” section.

1.To reset the minimum/ maximum readings, it is necessary to select which remote temperature/ humidity sensor you wish to reset. Next select the minimum or maximum record that you wish to reset. Finally press and release the IN/OUT, SET/CH button to reset the selected record.

Note: Before permanently mounting ensure that the indoor weather station is able to receive signals from remote temperature/humidity sensors at the desired location. Also, extreme and sudden changes in temperature will decrease the accuracy of the indoor weather station. To achieve a true temperature reading, avoid mounting where direct sunlight can reach the remote temperature/ humidity sensor or indoor weather station. While the remote temperature/ humidity sensor is weather proof, avoid submersion in water or snow. We recommend that you mount the remote temperature/ humidity sensor on an outside North-facing wall. The sending range is 80ft—obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units in their desired location, and wait approximately 15 minutes before permanently mounting to ensure that there is proper reception. The indoor weather station should display a temperature/