JetAudio iAUDIO U2 manual ConnectingiAUDIOandInstallingJetShell

48

ConnectingiAUDIOandInstallingJetShell

1.When you insert iAUDIO installation CD in the CD-ROM drive, the installation program starts automatically. It may not start automatically depending on the settings of Windows. In this case, run x:\setup.exe or x:\JetShell\setup.exe. (where x is the letter of your CD-ROM drive)

2.When the installation finishes, Start -> Program -> COWON -> iAUDIO U2 program group is created.

3.You are now ready to connect iAUDIO to PC (Don’t run JetShell at this time).

Connect the USB ports of iAUDIO to your PC using the provided USB cable.

(We recommend to connect iAUDIO to the PC directly, not using USB hub)

4.As soon as the cabe is connected, the message “Found New Hardware” appears and the USB driver for iAUDIO is installed automatically. The driver installation message may not appear on the screen depending on the status of Windows. To make sure that the installation was completed nor- mally, check for the device “iAUDIO” in My Computer as shown below, or “Control Panel -> System -> Hardware -> Device Manager”.

5. Now you can transfer files by using JetShell or Window Explorer.

iAUDIO U2