. Cleaning | . Functional faults |
Only use a slightly moist cloth to clean the case surface of the set. Ensure when cleaning that no moisture enters the set.
The inside of the CD compartment must only be cleaned with a clean, dry brush (e.g. lens brush available from pho- tographic dealers). NEVER moist clean the inside of the CD compartment!
Warning!
Moisture penetrating the set can give rise to the danger of an electric shock!
Only clean the laser scanning lens inside the CD compart- ment (if necessary) with a clean, dry brush. NEVER touch the laser scanning lens with bare hands!
Please note!
Only clean the laser scanning lens inside the CD compart- ment (if necessary) with a clean, dry brush. NEVER touch the laser scanning lens with bare hands!
Proceed in the following manner in the event of functional
faults of the set …
•First disconnect the plug from the mains socket or remove the batteries from the battery compartment.
•Check that there is at least 10 cm space above, behind and on either side of the set in relation to walls or objects.
If this is not the case, then switch off the set and allow it to cool down for at least one hour! Relocate the set in such a manner that the above minimum distances are observed.
•If audio CD playback is faulty or does not function at all, then this can indicate that a film of condensation has formed on the laser scanning lens in the CD compart- ment.
This can happen if the set has been exposed to wide tem- perature fluctuations.
In this event place the set in a dry environment with a normal room temperature and wait at least five hours before switching on the set again.
GB
Operating Instructions
Manual_KH2242_EN | 15 | 16.09.2003, 15:04 Uhr |