Programming the Scanner
3-7
Program & End
Scan
“PROGRAM”
Scanner enters programming mode,
and inhibits all non-programming functions.
Scan
“END”
Scanner exits programming mode, and stores all
parameters in Flash Memory ASIC or non-volatile memory,
then issues the completion beep (3 short beeps).
Please note that the scanner will take 3-4 seconds to store
parameters in internal Flash Memory ASIC or non-volatile
memory after you scan the “END.” Please do not turn off
the power before the completion beep. It may destroy all
configured parameters.
System List & Master Default
Scan “M_DEFAULT”
Scanner returns all programmable
parameters to factory preset configurations,
then issues the completion beep (3 short beeps).
Scan “SYSLIST”
Scanner lists the product information and
revision number to host via selected host interface,
then issues the completion beep (3 short beeps).