Hand Held Products 3220, 3060, 3080 manual Data Replacer Settings, Replacer Control, 1st Replacement

Programming the Scanner

Condensed Data Editor

♦ Data Replacer Settings ♦

PROGRAM				END(Exit)
Family Code Selection	Parameter Selection		Option Code	2nd Option Code
Replacer Control	Disable		FIN
	Select one bar code symbology		(2 digits)	automatic termination
	Select all bar code symbologies	00		automatic termination
1st Replacement	Disable		FIN
	Enable		(2-digit decimal	[ 00-7F ]
			value)
	2-digits identified position; 1 replacement character		position
2nd Replacement	Disable		FIN
	Enable		(2-digit decimal	[ 00-7F ]
			value)
	2-digits identified position; 1 replacement character		position
3rd Replacement	Disable		FIN
	Enable		(2-digit decimal	[ 00-7F ]
			value)
	2-digits identified position; 1 replacement character		position

FACTORY DEFAULT

The Data Replacer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code symbologies for replacer control, and provides Multiple Position Replacement in the identified position.

All data must conform to the Identified Bar Code Symbologies, and one to three Identified Characters in the identified position. While the Data Replacer is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID, or Record Suffix.

Please refer to page 3-37 for information about the “Bar Code Selection” and “Position Calculation” of Data Replacer. To determine the hex value for the “Character,” refer to the HEX/ASCII Table listed on page A-6.

Refer to page 3-12 for 2-digit symbology option code.

3-35