Programming the Scanner
3-33
Condensed Data Editor
♦ Data Formatter ♦
PROGRAM END(Exit)
Family Code Selection Parameter Selection Option Code 2nd Option Code
Formatter Control
Disable
Select one bar code symbology
Select all bar code symbologies
FIN
(2 digits)
00
automatic termination
automatic termination
1st Insertion
Disable
Enable
2-digits identified position; max. 3 insertion characters
FIN
(2 digits)
position
Hex value for each
character, (FIN)
1-3 characters to insert
2nd Insertion
Disable
Enable
2-digits identified position; max. 3 insertion characters
FIN
(2 digits)
position
Hex value for each
character, (FIN)
1-3 characters to insert
3rd Insertion
Disable
Enable
2-digits identified position; max. 3 insertion characters
FIN
(2 digits)
position
Hex value for each
character, (FIN)
1-3 characters to insert
4th Insertion
Disable
Enable
2-digits identified position; max. 3 insertion characters
FIN
(2 digits)
position
Hex value for each
character, (FIN)
1-3 characters to insert
FACTORY DEFAULT
The Data Formatter is used to edit the scanned raw data prior to transmitting the data to the host computer or terminal. It allows you to select desired bar code
symbologies for formatter control, and provides Multiple Position Insertion and Multiple Character Insertion (max three characters) in the identified position.
If the Data Formatter is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbolology ID or
Record Suffix. All of the above programmable parameters perform the same function depending on your setting.
Please refer to page 3-37 for information about the “Bar Code Selection” and “Position Calculation” of the data formatter.
To determine the hex value for the “Character,” refer to the HEX/ASCII Table on page A-6
Refer to page 3-12 for for the 2-digit symbology option code.