Hand Held Products 3080, 3060, 3220 Data Organizer Settings, Organizer Control, 1st Organization

Programming the Scanner

Condensed Data Editor

♦ Data Organizer Settings ♦

PROGRAM				END(Exit)
Family Code Selection	Parameter Selection		Option Code	2nd Option Code
Organizer Control	Disable		FIN
	Select one bar code symbology		(2 digits)	automatic termination
	Select all bar code symbologies	00		automatic termination
1st Organization	Disable		FIN	Direction :
	Enable		(2-digit decimal	0 (Before)
			value)	1 (After)
	2-digits identified character position;		position
	Transmit data before/after this position
2nd Organization	Disable		FIN	Direction :
	Enable		(2-digit decimal	0 (Before)
			value)	1 (After)
	2-digits identified position;		position
	Transmit data before/after this position
Include/Exclude Control	Transmitted data excluding the data of identified position	0
	Transmitted data including the data of identified position	1

FACTORY DEFAULT

The Data Organizer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code symbologies for organizer control, and provides a maximum of two identified positions to send the data before or after. It also allows you to control the transmitted data including or excluding the data of the identified position. Please refer to the application example on the next page for details.

While the Data Organizer is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID, or Record Suffix.

Please refer to the next page for information about the “Bar Code Selection” and “Position Calculation” of Data Organizer. To determine the hex value for the “Character,” refer to the HEX/ASCII Table listed on page A-6.

Refer to page 3-12 for 2-digit symbology option code.

3-36