Sony MDS-JE530 manual Self-DiagnosisFunction, 51GB

Menu item	Function	Parameters	Factory setting	Reference page(s)
Pitch	Changes the playback speed by auto steps.	–48 to +2	0	40
Pfine	Fine controls the playback speed.	–98.5 to +12.5%	0%	41
Ain	Adjusts the analog signal level input through	–∞ to +12.0dB	0.0dB	17
	the LINE (ANALOG) IN jacks.
Coax	Adjusts the digital signal level input through	–∞ to +18.0dB	0.0dB	17
	the DIGITAL COAXIAL IN jack.
Opt	Adjusts the digital signal level input through	–∞ to +18.0dB	0.0dB	17
	the DIGITAL OPTICAL IN connector.
Aout	Adjusts the analog signal level output to	–20.2 to 0.0dB	0.0dB	24
	the LINE (ANALOG) OUT and PHONES jacks.
Sleep	Sets the duration of Sleep Timer.	30/60/90/120min	60min	42
Sleep	Turns Sleep Timer on or off.	On/Off	Off	42

To recall a factory setting

Press CLEAR while selecting the parameter.

Self-Diagnosis Function

The deck’s self-diagnosis function automatically checks the condition of the MD deck when an error occurs, then issues a three-digit code and an error message on the display. If the code and message alternate, find them in the following table and perform the indicated countermeasure. Should the problem persist, consult your nearest Sony dealer.

Three-digit code/Message	Cause/Remedy
C11/Protected	The inserted MD is record-protected.
	, Take out the MD and close the record-protect slot (page 16).
C13/REC Error	The recording was not made properly.
	, Set the deck in a stable surface, and repeat the recording procedure.
	The inserted MD is dirty (with smudges, fingerprints, etc.), scratched, or substandard in quality.
	, Replace the disc and repeat the recording procedure.
C13/Read Error	The deck could not read the TOC on the MD properly.
	, Take out the MD and insert it again.
C14/Toc Error	The deck could not read the TOC on the MD properly.
	, Insert another disc.
	, If possible, erase all the tracks on the MD (page 32).
C71/Din Unlock	The sporadic appearance of this message is caused by the digital signal being recorded. This will not affect
	the recording.

While recording from a digital component connected through the DIGITAL IN connector, the digital connecting cable was unplugged or the digital component turned off.

,Connect the cable or turn the digital component back on.

Additional Information

51GB