Sony MDS-JE530 manual 28GB, Creating Your Own Programme Programme Play

Playing MDs

Creating Your Own Programme (Programme Play)

To enter a track number over 10 Z

Use >10. For details, see page 25.

To check the total playing time of the programme

Press LEVEL/DISPLAY/CHAR (or DISPLAY).

4Repeat step 3 to enter other tracks.

The entered track is added to the location where the “0” flashes.

Each time you enter a track, the total programme time appears in the display.

5Press YES.

“Complete!!” appears and the programme is completed.

6Press PLAY MODE repeatedly until “PROGRAM” lights up in the display.

7Press H.

Programme Play starts.

To stop Programme Play

Press x.

To resume normal play

Press PLAY MODE repeatedly until “PROGRAM” turns off.

zThe programme remains even after Programme Play ends or is stopped

Press H to play the programme again.

Notes

•If you turn off the deck or disconnect the mains lead, the programme will be lost.

•The display shows “- - - m - - s” when the total playing time of the programme exceeds 199 minutes.

•“ProgramFull!” appears when you try to programme 26th track.

Checking the contents of the programme

While the deck is stopped and “PROGRAM” lights up, press LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly.

The first several tracks in the programme appear in the display. To see the rest of the programme, turn AMS (or press ./> repeatedly).

Changing the contents of the programme

While the deck is stopped and “PROGRAM” lights up, do steps 1 and 2 of “Programming the tracks” on page 27, followed by one of the procedures below:

To	Do the following:
Erase a track	Press m/M repeatedly until the
	number of the unwanted track flashes,
	then press CLEAR.
Erase all tracks	Press CLEAR repeatedly until all the track
	numbers disappear.
Add a track at the	Press m repeatedly until “0” flashes
beginning of the	before the first track number, then do steps
programme	3 to 5 of “Programming the tracks” on
	pages 27 and 28.
Add a track in the	Press m/M repeatedly until the track
middle of the	number which will precede the new track
programme	flashes. Press AMS to display flashing
	“0, ” then do steps 3 to 5 of “Programming
	the tracks” on pages 27 and 28.
Add a track to the	Press M repeatedly until “0” flashes
end of the	after the last track number, then do steps
programme	3 to 5 of “Programming the tracks” on
	pages 27 and 28.
Replace a track	Press m/M repeatedly until the
	number of the track to be changed flashes,
	then do steps 3 to 5 of “Programming the
	tracks” on pages 27 and 28.

28GB