In the CONTROL A1 control system, the control signals flow both ways, so there is no distinction of IN and OUT jacks. If a component has more than one CONTROL A1 jack, you can use either one, or connect different components to each jack.

Jacks and connection examples

CD player

MD deck

On CONTROL A1 jacks and connections

It is possible to make connections between CONTROL A1 and CONTROL A1jacks. For details regarding particular connections or setup options, refer to the operating instructions supplied with component(s).

About the connecting cable

Some CONTROL A1compatible components are supplied with a connecting cable as an accessory. In this case, use the connecting cable for your connection. When using a commercially available cable, use a monaural (2P) mini-plug cable less than 2 meters long, with no resistance (like the Sony RK-G69HG).

Basic Functions of the CONTROL A1 Control System

Automatic function selection

 

When you connect CONTROL A1

compatible Sony

components using CONTROL A1

cables (not supplied),

the function selector on the amplifier (or receiver) automatically switches to the correct input when you press the play button on one of the connected components.

(If you press H (play button) on the MD deck while the CD is playing, the function selector on the amplifier switches from CD to MD.)

Notes

This function only works when the components are connected to the amplifier (or receiver) inputs according to the names on the function buttons. Certain receivers allow you to switch the names of the function buttons. In this case, refer to the operating instructions supplied with the receiver.

When recording, do not play any components other than the recording source. It will cause the automatic function selection to operate.

Synchronized recording

This function lets you conduct synchronized recording between the MD deck and selected source component.

1Set the source selector on the amplifier (or receiver) to the source component.

2Set the source component to pause mode (make sure both the H and X indicators light together).

3Set the deck to recording pause mode.

4Press X on the deck.

The source component is released from the pause mode, and recording begins shortly thereafter. When playback ends from the source component, recording stops.

Notes

Do not set more than one component to the pause mode.

This MD deck is equipped with a special synchronized

recording function that uses the CONTROL A1 Control System (see “Making a CD Synchro-recording from a Sony CD player connected with a control A1 cable” on page 22).

Getting Started

7GB

Page 7
Image 7
Sony MDS-JE530 manual Basic Functions of the Control A1 Control System, On Control A1 jacks and connections