Schlage SRP-275 user manual DIP Switch setting for StarSP500 mode, Emulation Selection DSW 1-1

					SRP-275
3-1-3 DIP Switch setting for Star(SP500) mode
• DIP Switch 1
Switch	Function		ON	OFF		Default
1-1	Emulation Selection (*1)		Refer to the following table			OFF
1-2
1-3	Auto cutter		Enable	Disable		OFF
1-4	Black/Red Printing		Enable	Disable		OFF
1-5
1-6		Reserved				OFF
1-7
1-8

• DIP Switch 2 (RS232C serial interface model)

Switch		Function			ON	OFF	Default
2-1			Reserved				OFF
2-2
2-3	Hand shaking			XON/XOFF		DTR/DSR	OFF
2-4	Word length				7 bits	8 bits	OFF
2-5	Parity check				Enable	Disable	OFF
2-6	Parity selection				EVEN	ODD	OFF
2-7	Baud rate selection (*2)				Refer to the following table		OFF
2-8							OFF
NOTES
(*1) Emulation Selection (DSW 1-1 and 1-2)
Emulation		1-1	1-2
EPSON		OFF	OFF
STAR		OFF	ON
CITIZEN		ON	OFF
EPSON-KP		ON	ON

- EPSON-KP(EPSON Kitchen Printer mode) : A alarm is generated by printer after auto cutting and in paper end error.

(*2) Baud rate selection (Transmission speed)

Transmission	2-7	2-8
2400 baud	ON	ON
4800 baud	OFF	ON
9600 baud	OFF	OFF
19200 baud	ON	OFF

NOTICE

Change in DIP Switch settings are recognized only when the printer power is turned on or when the printer is reset by using the interface. If the DIP Switch setting is changed after the printer power is turned on, the change does not take effect until the printer is turned on again or is reset.

Rev. 1.01 - 16 -