Initial Configuration of the Switch

5.Set up the properties for the terminal connection. In Windows NT 4.0:

a.Double-click the Hypertrm icon.

b.Enter a name for the connection in the New Connection dialog box, select an icon to represent the switch for future use, and click OK.

The Connect To dialog box is displayed.

6.From the Connect using drop-down menu, select the communications port assigned to the serial port (for example, COM1, COM2) and click OK. In the properties dialog box, enter the following port settings and select OK.

Table 2-1: Default Serial Port Settings

Type

Setting

Bits per second (baud rate)

38,600

 

 

Data bits

8

 

 

Parity

None

 

 

Stop bits

1

 

 

Flow control

None

 

 

7.Select File￿Properties to show the connection properties dialog box. Select the Settings tab. From the Emulation pull-down menu, select VT100 and click OK.

8.Power ON all peripheral device(s).

9.Wait at least ten seconds and power cycle the MSA1000. The switch sends a series of Power-on Self-Test (POST) messages in HyperTerminal.

2-4

Modular SAN Array Fabric Switch 6 User Guide

Page 21
Image 21
Compaq 230934-002, Switch 6 manual Default Serial Port Settings