Compaq 230934-002, Switch 6 manual Port Control Panel

MSA Fabric Switch 6 Management Utility

The Port Control panel displays current information about the port as described in the following table.

Table 3-6: Port Control Panel

Parameters	Description
Status	Displays one of the following:
	Failed Diagnostics = could not initialize the port; the port has failed.
	Loopback mode = loopback cable is attached.
	Offline = port was taken offline by management.
	No media installed = no SFP installed.
	Link down = SFP is installed but with no link established.
	Link up = SFP is installed and a link to the device is established.
	Link active = SFP is installed, a link to the device is established, and
	traffic is flowing.
	Isolated = it is understood that the other port is an E-port but complete
	initialization cannot be established.
Media Type	Displays the media type plugged into the port or that no media interface
	is installed.
Detected Port Type	Indicates the current port configuration as an F-port, FL-port or E-port,
	or other type port.
Set Port Type	Allows you to configure the port as one of the following: F-port, FL-port,
	E-port, Auto
Port State	Displays and allows you to select these values:
	On Line = Port is enabled on the Fibre Channel network.
	Off Line = Port is disabled from operating on the Fibre Channel network.
	continued

3-22 Modular SAN Array Fabric Switch 6 User Guide