Compaq Switch 6, 230934-002 manual Network Tab, Network tab

MSA Fabric Switch 6 Management Utility

Network Tab

The Network window is accessed by clicking the “Network” tab of the System Information display. It consists of the following two panels:

•IP Configuration

•SNMP Trap Management Stations

NOTE: The System Information - Network Tab page will not function properly without a valid gateway address. If you are using the default gateway address (0.0.0.0) or an invalid gateway address, you will need to change the address to a valid one. To check the gateway address on your system using the CLI, see the section titled “NetCfg”. To change the gateway address using the CLI, see the section titled “Setting the Gateway Address.”

IP Configuration This panel, as shown in the following figure, displays all of the IP networking parameters that were set on the Fabric Switch 6 using the serial interface.

Figure 3-27: Network tab

Modular SAN Array Fabric Switch 6 User Guide 3-39