LED Indicators
All models have two LED indicators on the top. The Status/Error LED is orange or red. The Power/Link indicator LED is green. The LED indicator modes are described in the following table.
Green LED | Red/Orange LED | Status Description |
|
|
|
Off | Off | No power. |
|
|
|
On | On | Hardware error. |
|
|
|
Flashing | Flashing | Firmware upgrade in progress. |
|
|
|
On | Flashing (USB only) | No printer connected to the USB port. |
|
|
|
On | Off | Normal operation - idle. |
|
|
|
Flashing | Off | Normal operation - transmitting or |
|
| receiving packets from the network. |
|
|
|
LEDs - WPS-0100 and WPS-0100USB
The
LED | Description |
|
|
WLAN ACT | Off - Idle |
| Flashing - Transmitting or receiving data through the Wireless |
| LAN. |
|
|
LAN ACT | Off - Idle |
| Flashing - Transmitting or receiving data through the LAN. |
|
|
Diagnostic Push Button
LevelOne Printer Server models
Push Button. The button is recessed; a pin or paper clip can be used to press it. This button has
2 functions:
∙Restore the factory default settings
∙Print a test page containing all current settings.
To restore the factory default settings:
1.Turn the LevelOne Printer Server OFF.
2.Press and hold the diagnostic button. While pressing the button, switch the LevelOne Printer Server ON.
3.If you continue pressing the button for 10 seconds, a diagnostic page will be printed, showing the new (default) settings.
To generate a Diagnostic print out
1.Ensure that both the LevelOne Printer Server and the printer attached to port 1 are ON.
2.Press the diagnostic button, and hold it in for 2 seconds.
Page 6
