
InitDevice Menu
Attach Remote | This is used to connect to a LevelOne Printer Server device on another |
| LAN segment. If your LAN does not have a Router, ignore this option. |
Connected | This option allows you to designate which LAN protocol will be used |
Protocol | for communication between the selected device and this application. |
| You should select ONE protocol only. |
Find | Use this option to use the IPX/SPX protocol to locate a LevelOne |
| Printer Server on the LAN. Simply enter the Default Name of the |
| LevelOne Printer Server you wish to locate. The Default Server Name |
| is shown on a sticker on the base of the device. |
Reset Device | This will cause the device to reboot. This should be done after making |
| any configuration changes, or if the device stops responding after some |
| problems. |
Restore Factory | This will restore ALL device values to their factory defaults. To restore |
Default | only the current screen, use the Set to Default button on the screen. |
Set IP Address | For TCP/IP networks only: |
| ∙ If a LevelOne Printer Server does not appear on the main screen, |
| use this option to set a Device IP Address, Gateway IP Address, |
| and Network Mask to the LevelOne Printer Server. |
| ∙ This should only be necessary if your LAN is using ONLY the |
| TCP/IP protocol. In other cases, BiAdmin will use IPX/SPX to |
| locate the LevelOne Printer Server even if it doesn't have a valid |
| IP Address. |
| ∙ To locate the LevelOne Printer Server, enter the Default Name . |
| The Default Server Name is shown on a sticker on the base of the |
| device. |
| ∙ Enter the required IP Address, Network Mask, and Gateway IP |
| Address. |
| ∙ After saving the data to the device, refresh the listing. The |
| LevelOne Printer Server should then appear in the device list on |
| the main screen. |
Upgrade | Upgrade the firmware in a LevelOne Printer Server. See Upgrade Icon |
| for details. |
Page 31