TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee.
English
PROBLEM
–POSSIBLE CAUSE
• REMEDY
No sound/power
–VOLUME not adjusted
• Adjust the VOLUME
–Headphones connected
• Disconnect headphones
–Mains lead not securely connected
• Connect the mains lead properly
Severe radio hum or noise
–Electrical interference: set too close to TV, VCR or computer
• Increase the distance
indication
–
• Use a finalised
–CD badly scratched or dirty
•Replace/ clean CD, see CD player and CD handling
The CD skips tracks
–CD is damaged or dirty
• Replace or clean the CD
–SHUFFLE or a programme is active
• Switch off SHUFFLE/PROGRAM
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
Poor radio reception
–Weak radio signal
•FM: Direct the FM telescopic aerial for optimum reception
•MW/LW: Turn the set for optimum reception
–Use of incompatible cassette types (METAL or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
– Cassette tab(s) may be broken
or 
indication
–No CD inserted
• Insert a CD
–CD badly scratched or dirty
•Replace/ clean CD, see CD player and CD handling
–Laser lens steamed up
• Wait until lens has cleared
•Apply a piece of adhesive tape over the missing tab space
Remote control does not function properly
–Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
–Distance/ angle between the set too large
• Reduce the distance/ angle
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.
13