Lenoxx Electronics CD-91 Trouble Shooting Guide, M P T O M S U S E S L U T I O N S

TROUBLE SHOOTING GUIDE

Check the following guide before calling customer service.

S Y M P T O M S	C A U S E S			S O L U T I O N S
Tracks do not	Batteries are too weak (they			Replace both batteries with fresh alkaline batteries.
change or set does	may test OK on tester, but			Battery life with fresh batteries is about 8 hours
not play normally.	they are weak).			(rechargeable batteries have 1/2 of that life).
CD Player will not	Dead or weak batteries.			Replace both batteries with fresh ones.
	AC Adaptor not connected			Check AC Adaptor connections at the AC outlet
turn on.
	properly.			and the rear of set.
	Disc inserted incorrectly.			Re-insert disc with label side facing up.
Disc will not play.	Defective compact disc.			Try another compact disc (scratched and dirty
				discs will not play).
	CD Door not closed.			Close the Door (lid) securely.
	Moisture has formed inside			Take out the CD and leave the CD Door open for
	the CD deck.			about an hour to dry the moisture condensation.
	Headphone plug not inserted			Re-insert headphone plug into Phones Jack
No sound from	properly.			(not Aux Out).
headphones.	Volume	Control set	to	Increase the volume.
	minimum.
	Weak batteries.			Replace with fresh batteries or use AC Adaptor.
	Defective compact disc.			Try another compact disc.
Volume Control	Headphones plugged		into	Plug headphones into Phones Jack .
has no function	Aux Out Jack.			(NOT THE AUX OUT JACK)
Sound is skipping	The compact disc or lens is			Clean or replace the compact disc or clean the
	dirty or CD is scratched.			lens.
or sound stops.
	Strong vibrations.			Place the CD player on a level surface that is
				stable or press ESP Button.
	Anti-skip is off.			Turn on ESP function.
Sound is distorted.	Music is too loud.			Lower Volume Control.
	Bass Boost Switch is ON.			Press Bass Boost Switch to OFF.
	Weak batteries.			Replace both batteries or use AC Adaptor.
Buttons do not	Electronic	or static error		Remove batteries and Adaptors. Wait a few
work.	caused circuitry to lock.			seconds and re-insert. Make sure batteries are
				fresh or Adaptor has power.

15