Lenoxx Electronics CD-91 operating instructions Playing a Disc, T E

Page 8

PLAYING A DISC

1.Plug the cord from the headphones into the Phones Jack on the right side of the set.

IMPORTANT: Do not plug the headphones into the Aux Out Jack. If you do, the sound will be very low and the Volume

Control will not work.

2. Slide the CD Door Open Button to open the CD Door.

OPEN

3.Hold the disc with the LABEL SIDE UP and press it onto the spindle until it “clicks” into

place.

4.Close the CD Door (it will latch shut), press the Play Button (Power On), the disc will begin to

spin, the display will show “ ” and then the total tracks and total playing time, then it will begin playing track number 1 (song #1).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

TOTAL NUMBER

TOTAL PLAYING

TRACK NUMBER

ELAPSED PLAYING

OF TRACKS

TIME ON THE DISC

CURRENTLY

TIME OF THE

N O T E :

 

 

 

 

 

 

PLAYING

CURRENT TRACK

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1. If the Display shows “

”, the CD is

upside down or missing.

 

 

 

 

 

 

2.When the symbol “ ” flashes in the Display, your batteries are weak and need replacement.

5.Adjust the Volume Control as desired.

6.Slide the Bass Boost Switch to ON for more bass, OFF for less bass (BASS means low frequency sounds like a bass drum).

7.If you are using your set in a car or bumpy location, press the ESP Button (see page 9) (this is not needed if your set will sit on a table or night stand).

N O T E :Display will show “

”, indicating that

you are in ESP mode, the basket will gradually fill.

8.To stop playing temporarily, press the Play/Pause Button.

The elapsed playing time FLASHES in the Display.

Press the Play/Pause Button again to resume normal play.

9.To stop play, press the Stop Button. Total tracks and time will appear in the Display and after about 30 seconds the power turns off automatically. To shut the power off quickly, press the Stop Button twice slowly.

X 2

STOP

NOTE: The power turns off automatically when all tracks on a disc have been played.

The power turns off immediately when the CD Door is opened.

The power turns off when the Stop Button is pressed slowly twice.

POWER ON

Close the Door and press the Play Button.

POWER OFF

Press the Stop Button twice (please remember to press the Stop Button before opening the CD Door).

N O T E : If the time display flashes, your set is in the Pause mode, press Play again to play the disc.

7

Image 8
Contents Please Read Carefully Before USE Introduction Accessories IncludedAC Adaptor Stereo Headphones Power Sources Battery OperationTips on Battery USE Battery ReplacementAC Adaptor Operation Location of Controls Cleaning Discs Listening with HeadphonesConnections Handling Compact DiscsPresetting Stations Radio OperationPlaying a Disc T EBass Boost Switch Auto Power OFF FunctionIf Buttons do not Work RememberALL Memory is Used UP REPEAT, Intro and Random Play Intro PlayProgram Programming Your Playing Sequence Programmed PlayCleaning the Lens Connecting to Home Stereo SystemsCleaning the Cabinet Safety Precautions CondensationImportant Information Required by the FCC Safety CertificationLaser Safety Trouble Shooting Guide M P T O M S U S E S L U T I O N SSpecial Note about Batteries CD Player SectionGeneral Limited Warranty Playing a Disc Powering UPPlugging Volume Control Bass BoostRepeat ESP