Messages
The following messages or service numbers appear on the television or unit’s display when something unusual is detected during startup and use.
On the television
Cannot play.
≥You inserted an incompatible disc. (Discs recorded in PAL video, etc.)
Cannot display on this unit.
≥You tried to play a
No disc is inserted.
≥The disc may be upside down.
$This operation is not available.
≥Some operations are unsupported by the unit. For example;
reverse
IP address is not set.
≥The “IP Address” in “IP Address / DNS Settings” is
No Video
≥Depending on the connected iPod/iPhone, video menu may not be available on the TV. Select “ALL” on the unit’s display and operate video playback from your iPod/iPhone menu.
(> 29)
On the unit’s display
F99
≥The unit fails to operate properly. Press [POWER Í/I] on the main unit to switch the unit to standby for 3 seconds. Now press [POWER Í/I] on the main unit again to turn the unit on.
U59
≥The unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears.
Select a position with good ventilation when installing the unit. Do not block the ventilation hole on the rear and side of the unit.
HDMI ONLY
≥Some
NET
≥While connecting to a network.
No PLAY
≥There is a viewing restriction on a
No READ
≥The media is dirty or badly scratched. The unit cannot play.
PLEASE WAIT
≥The unit is carrying out an internal process.This is not a malfunction. You cannot operate the unit while “PLEASE WAIT” is displayed.
SET
(“ ” stands for a number.)
≥The remote control and main unit are using different codes. Change the code on the remote control.
Press and hold [OK] and the indicated number button at the same time for more than 5 seconds.
Hor F
(“ ” stands for a number.)
≥Check and correct the speaker cable connections.
≥There is something unusual.
≥Check the unit using the troubleshooting guide. If the service number does not disappear, do the following.
1Disconnect the plug from the household AC outlet, wait a
few seconds, then reconnect it.
2Press [POWER Í/I] to turn the power on.
If the service number does not disappear despite doing the above, request service from the dealer. Inform the dealer of the service number when requesting service.
UPD/
(“ ” stands for a number.)
≥The firmware is being updated. Please do not turn off power.
IPOD OVER CURRENT ERROR
≥The iPod/iPhone is drawing too much power. Remove the iPod/iPhone, and turn the unit off and on again.
START
≥The system is being restarted during the firmware update. Please do not turn off power.
FINISH
≥The firmware update is completed.
NOT CONDITIONAL
≥The requested operation cannot be conducted.
Reference
VQT3M40
39