Freecom Technologies MediaPlayer Drive-In Kit manual Connecting the player to the PC

Use as External USB HDD

4. Put the 4 screws back

GB

1

1.2 Connecting the player to the PC

1.Connect the USB cable to the player and connect the power adapter to the DC jack on the player.

2.Connect the adapter into an AC outlet.

3.Connect the player to the PC's USB port.

4.Switch the power on by pressing the power on-off button on the player

5.Windows 2000 and Windows XP will recognize the player as a USB drive automatically; you can use the player without installing a driver.

Note: for use under Windows98SE, you have to install the USB2.0 driver from the manual CD.

6.If the player is not recognized or detected, please check if the USB connector is properly connected to the device and the PC.

1.3 Format the Built-in HDD via USB

If the assembled HDD is not formatted, a PC will not detect the hard disk drive. If your harddisk is not formatted,follow the below mentioned instructions. If the hard disk drive is already formatted, you can discard below steps and go to "1.4 Copy Data via USB".

11