Freecom Technologies MediaPlayer Drive-In Kit manual Use as External USB HDD

Use as External USB HDD

8.Select Option 1 "(Create primary DOS partition)" by pressing '1' and confirm with 'Return'.

Wait until drive integrity is completely checked.

9.If only one partition is required then answer "Y" to the question: "Do you wish to use the maximumavailable size for a Primary DOS partition?" If more than on partition is required go to the next section "Create two or more partitions on the Network MediaPlayer-35 drive in kit under Windows 98 / Windows ME".

Now the whole disk will be partitioned as one primary partition. Wait until the drive integrity check is completed.

10.Press the 'ESC' key to return to the fdisk options.

11.Now press the 'ESC' key to close the "fdisk window". Your hard disk is now partitioned.

12.Stop your hard disk by using the hot unplug icon in the lower right corner of your screen and remove the USB cable from your hard disk. Afterwards connect your hard disk again with your computer. The hard disk will now be recognized by Windows.

As Windows tries to access your hard disk an error message will appear. This happens, because your hard disk is not yet formatted.

Creating two or more partitions on the Network MediaPlayer-35 drive in kit under Windows 98SE / ME

1.Repeat steps 1 to 7 from the previous chapter (Create one partition on the Network MediaPlayer-35 drive in kit under Windows 98SE/Windows ME).

2.Answer the question "Do you wish to use the maximum available size for a primary DOS partition?" with "N".

3.Enter either the size or a percentage value for the partition size. Press 'Return' and wait until the drive integrity check is completed.

GB

1

15