Emerson Process Management rosemount 3300 series manual 5525066$*6, $/$50$15,7 3527&7,21

SWITCH_WRP_ALARM_DISPLAY

	5HIHUHQFH￿0DQXDO
Rosemount 3300 Series	00809-0100-4811, Rev AA
	October 2002

(5525￿0(66$*(6	The display can alos be used for presentation of software errors. The upper
	row shows error codes and the lower row shows ’ERROR’.
Figure 5-2. Presentation of error		￿￿￿￿￿￿￿￿￿￿
messages
		L￿￿￿)￿2
		ERRORDISPLAY
	The￿￿￿￿following￿￿￿￿￿errors can be displayed:
	CNFIG	Invalid Configuration
	00001	Ram Failure
	00002	ROM Checksum
	00006	Waveform Acquisition Failure
	00007	EEprom Factory Checksum
	00010	Software Error
	00013	Probe Failure

$/$50￿$1'￿:5,7(￿ 3527(&7,21

Figure 5-3. Alarm and Write Protection switches.

See also “Errors.” on page 6-20.

When mounting the Integral Display panel it is important that*￿￿￿￿￿;￿￿￿￿the Alarm and Write Protection switches on the transmitter mother board are correctly set.

Make sure that the Alarm switch is in the HIGH position and the Write Protection switch is in the OFF position, see Figure 5-3.See also 6HFWLRQ ￿￿￿

%HIRUH￿<RX￿,QVWDOO for more information.

Once the mother board positions are set, then the display positions become the master.

5-2