Emerson Process Management rosemount 3300 series manual Uuruv

Rosemount 3300 Series

5HIHUHQFH￿0DQXDO

00809-0100-4811, Rev AA October 2002

(UURUV￿	Table 6-2 is a list of diagnostic messages that may be displayed on the
	Integral Display, on the Model 275 HART Communicator, in AMS or by the
	Radar Configuration Tools (RCT) software. Errors normally result in Analog
	Output alarm.
	Errors are indicated in RCT by the message “Transmitter malfunction”:
		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿	TRANSMITTERMALFUNCTION

To see the error message do one of the following:

• Click the Read Gauge Status icon	in the toolbar at the top of the
RCT workspace.

•1. Open the Advanced section in the RCT workspace Project Bar and click the Device Commands icon,

or

choose the Device Commands option from the View menu.

2. Open the folder named Diag and double-click the Read Gauge Status option.

Table 6-2. Error messages.

Invalid configuration.	At least one configuration parameter	•	Load default database and restart
	is outside allowed range.		the transmitter.
	NOTE: the default values are used	• Contact Saab Rosemount service
	until the problem is solved.		department if the problem persists.
RAM failure was	The transmitter performs an	Contact Rosemount service
detected during	immediate reset.	department.
startup test.
FPROM failure was	The transmitter performs an	Contact Rosemount service
detected during	immediate reset.	department.
startup test.
Waveform acquisition	This error is probably caused by	Contact Rosemount service
failure.	hardware failure.	department.
EEPROM factory	Checksum error in the factory	Contact Rosemount service
checksum.	configuration parameters. Can be	department.
	caused by power failure during
	configuration or by hardware error.
	NOTE: the default values are used
	until the problem is solved.
EEprom user	Caused by error in the User	•	Load default database and restart
checksum error.	Configuration parameters. Can be		the transmitter.
	caused by power failure during	•	Contact Saab Rosemount service
	configuration or by hardware error.		department if the problem persists.
	NOTE: the default values are used
	until the problem is solved
Software error.		Contact Rosemount service
		department.
Probe failure.	Probe is not detected.	Check that the probe is correctly
		mounted.

6-20