Actiontec electronic MWTV200KIT01 user manual Receiver Rear Panel

Page 11

MyWirelessTV User Manual

Power LED e Power LED, located on the front of the Receiver, is used to display the state of the Receiver’s power. If unlit, the unit is o . If lit, the unit is on.

USB Port e USB port, located on the front of the Receiver, is used to connect a USB stick drive to the Receiver when a rmware update is available. See “Updating MyWirelessTV’s Firmware” for more details. It is also used for the USB Backchannel feature.

Receiver Rear Panel

Reset Button e Reset button, located on the back of the Receiver, is used to reset the Receiver to factory default settings.

Power Port e Power port, located on the back of the Receiver, is used to connect the Power cord to the Receiver.

HDMI Out to TV Port is port, located on the back of the Receiver, is used, via an HDMI cable, to connect the Receiver to an HDMI-ready display, such as a high-de nition TV.

IR Port is port, located on the back of the Receiver, is used to connect the IR Receiver cable, used to extend the range of the source device’s remote control (in conjunction with the IR Blaster cable connected to the Transmitter).

10

Image 11

Contents MyWirelessTV Table of Contents Speci cations TroubleshootingFrequently Asked Questions General LED Indicators GPL LicenseMinimum System Requirements IntroductionFeatures Product Contents Transmitter Front Panel Getting To Know MyWirelessTVMyWirelessTV Transmitter Page Transmitter Rear Panel Receiver Front Panel MyWirelessTV ReceiverReceiver Rear Panel Connecting the MyWirelessTV Transmitter Connecting MyWirelessTVConnecting the MyWirelessTV Receiver Connecting the IR Blaster Cable Setting Up IR ControlConnecting the IR Extender Cable Transmitter Typical MyWirelessTV Connection Con gurationReceiver Connecting to a Computer as a Source DeviceUsing USB Backchannel Remote Control Using the MyWirelessTV Graphical User InterfaceDirection Up, Down, Left, Right ButtonsSelect Source Shortcut MenuExit BackInformation Graphical User Interface Select Source Add Transmitter Con gureLabel Receiver Label TransmitterDelete Transmitter Language General SettingsWireless Channel Latency ModeSystem Information Advanced SettingsReset to Factory Updating MyWirelessTV FirmwareLEDs are ashing Why can’t I see anything on the TV next to the Receiver? TroubleshootingFrequently Asked Questions Why can’t I see anything on the TV next to the Transmitter?Page What is the remote control used for? Technical Speci cations Speci cationsGeneral Video Speci cationsGPL License LED Indicators