MyWirelessTV User Manual
Setting Up IR Control
MyWirelessTV comes with an IR Blaster and IR Receiver, which work together to allow you to control the source device from the location you are watching, whether it’s in the next room or on the other side of the house. For example, if your
Note: If you are using MyWirelessTV in the same location (i.e., the source device and the HDTV monitor are in the same room), the IR Blaster/ Receiver is not needed.
Connecting the IR Extender Cable
e IR Extender cable receives signals from the source device remote control and sends them back to the source device.
1.Get the IR Extender cable (it has a green connector) from the MyWirelessTV kit.
2.Plug the IR Extender’s green connector into the green IR port on the back of the Receiver.
3.Remove the protective covering of the
monitor’s bezel or frame
Connecting the IR Blaster Cable
e IR Blaster cable receives the source device remote control signal from the Receiver and delivers it to the source device.
1.Get the IR Blaster cable (it has a black connector) from the MyWirelessTV kit.
2.Plug the black connector of the IR Blaster cable into the IR Transmit port on the back of the Transmitter.
13