Installation
Using the remote control
IMPORTANT!
– Remove the
protective plastic tab before using the remote control.
– Always point the
remote control directly towards IR area .
To replace the battery
1Press and hold 1 as indicated
2Simultaneously, pull the battery tray at 4
3Remove the old battery and put a new CR2025 battery in place
4Put back the battery tray
12
3 |
| CR 2 |
L | 025 | |
ITHIUM |
|
CAUTION!
–Remove the battery if it is exhausted or will not be used for a long time.
–Batteries contain chemical substances, so they should be disposed of properly.
Perchlorate
Setting the clock
The time is displayed using the
1On the set, press and hold CLOCK
➜The hour digits start flashing (AM 12: 00 by default)
2Hold down or press ∞ or § repeatedly to set the hour
3Press CLOCK to confirm the setting ➜ The minute digits start flashing
4Repeat step 3 to set the minute
5Press CLOCK to confirm the setting
➜The clock shows the set time
To turn on the Daylight Saving Time (DST) mode
1In the standby mode, press and hold DISP on the set
➜ Current time setting moves ahead by 1 hour. DSTappears
2Press DISP again
➜ The set returns to normal time setting. DSTdisappears
English
9