Philips AJ6110 quick start Troubleshooting, English Problem, Solution

Troubleshooting

WARNING

Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or PHILIPS for help.

English

Problem

nocdor Errindication

No sound

The system does not react when buttons are pressed.

Remote control does not work

Radio reception is poor

The Clock setting is erased

Solution

✔No disc inserted. Insert a suitable disc

✔Replace/clean CD

✔CD-R(W) is blank or the disc is not finalized. Use a finalized CD-R(W)

✔Moisture has condensed in the player. Remove the disc and leave the player power-on until the moisture evaporates.

✔Check whether the set is connected securely.

✔Make sure the set is not in the MUTE mode. If it is, press MUTE to turn on the speaker.

✔Check whether the volume on the set has been set to the lowest level. If it has, turn up the volume.

✔CD-ROM disc inserted/CD contains non-audio files. Use CD Audio discs only.

✔Remove and reconnect the AC power plug and switch on the system again.

✔Remove the protective plastic tab before using the remote control.

✔Reduce the distance between the remote control and the set.

✔Replace the battery.

✔Point the remote control directly towards the IR sensor.

✔If the signal is too weak, adjust the antenna or connect an external antenna for better reception.

✔Increase the distance between the set and a TV, VCR or radiation source.

✔Power has been interrupted or the power cord has been disconnected. Reset the clock.

17