Temperature Operation

Using AUX IN Jack to enjoy your iPod, MP3 or other audio source

This clock radio is equipped with AUX IN Jack to enjoy your iPod, MP3 player music or other audio source.

1.Turn on the clock radio by pressing the RADIO ON/OFF button.

2.Connect your iPod, MP3 player or other audio source from its earphone jack to the clock radio AUX IN jack with a cable with 2 ends 3.5mm stereo plug. (cable not included)

3."AUX" indicator will light on the display while the AUX IN jack is plugged in, and the radio will change to AUX function.

4.Start to play iPod, MP3 or other audio player, and set the player volume to maximum.

5.Adjust the main unit volume to your desired level.

6.Stop the main unit and your iPod, MP3 or other audio player when finished listening, and disconnect the cable from the AUX IN jack.

NOTE:

1.Once AUX IN jack is plugged in, the alarm will default to Wake to buzzer, if the alarm function is activated.

2.When the alarm time is reached, the music will be muted, and the Buzzer will sound. Press the RADIO ON/OFF button twice to play the music again.

Set-up The Wireless Thermo Sensor Transmitter:

Slide open battery door. Install two “AAA” size batteries (not included), matching the polarity (+/-) in the battery compartment.

Outdoor Temperature Display

Note:

If the battery power drops below a certain level, the low battery symbol will flash on the outdoor temperature display. The batteries should be changed.

When replacing the batteries or during an interruption with the transmitter, the main unit can not display the correct temperature, please refer to the section “ TO SYNCHRONIZE OUTDOOR TEMPERATURE” procedure, step 4 - 6.

To Synchronize Outdoor Temperature:

1.Before the main unit receives the temperature data from the Wireless Thermo Sensor. You have to complete the code synchronizing communication between the wireless Thermo Sensor and main unit.

2.Insert the plug of main unit into the AC outlet, the main unit will show the indoor temperature at once on the indoor temperature display.

3.The outdoor temperature display will appear “F - -” or “C - -”. (Fahrenheit or Centrigade).

4.Use a pointed non-metallic object, such as pencil tip to press the “SYNC” button which is located at the bottom of the main unit to initiate the wireless Thermo Sensor code synchronization.