Using The Remote Control Unit
Alarm Reset/ | iPod Play/Pause Button | |
Power On/Off Button | >> Button | |
<< Button | ||
Volume + Button | ||
Volume - Button | ||
| ||
Radio/Aux Button | Preset Button | |
| ||
Snooze/Dimmer Button | 3D Button |
Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, it is time
to replace the battery with a new one.
1. The battery door is located on the back end of the remote control. 2. Pull the battery door to release the battery door latch and take out
the battery.
3. Insert a CR2032 battery, checking that the + and – sides of the battery matches the drawing inside the battery compartment.
4. Replace the battery door.
Note: Make sure you dispose of batteries properly (see your local regulations).
The Remote Control controls basic functions on the iH12 and certain iPod functions when the iPod is docked in the iH12. For best results, aim remote control towards the remote sensor on the upper left corner of the unit.
To check for iPod compatibility
iH12 is an advanced system and supports most updated iPod features. To ensure your iPod works properly with the iH12, please update your iPod firmware with the latest version, available on the Apple website (www.Apple.com).
4