Using the Alarms, Charging your iPod

Using the Alarms

Setting the Alarms

1.Press and hold the Alarm-1or Alarm-2 Button until the alarm time blinks in the lower part of the display. Press the << or >> Button to set the alarm time. Holding the button for a few seconds will advance or reverse rapidly. Remember to set the correct AM or PM time.

2.Press the Wake-to Button to select iPod, Radio or Buzzer alarm source. You can set different alarm sources for each alarm.

3.Press the Alarm Button again or wait for 10 seconds. Alarm is now armed, indicated by the numbered alarm clock icon.

Review, Arming and Disarming Alarm (Turn Alarm Function On and Off)

1.Press Alarm 1 (or Alarm 2) Button once. The unit will show the alarm time on the bottom part of the display for alarm time review.

2.During alarm review, press the Alarm 1 or Alarm 2 button again to arm or disarm the alarm. When the alarm is armed, the related alarm icon appears in display.

Resetting the Alarm to Come on the Next Day

1.When the alarm is sounding, press the Alarm Reset/Power On/Off Button to stop the alarm and reset it to come on the following day at the same time.

Snooze

1.Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again 9 minutes later. Snooze can be press several times during the 1 hour alarm cycle.

Sure Alarm

The iH12 has a sure alarm feature. If backup batteries are installed (see page 3) the buzzer alarm will still sound in the event of a power failure.

Charging your iPod

Note: Please make sure you are using the correct insert for your iPod (see Install iPod Insert) and that it is properly docked into the iH12. Failure to do so may damage your iPod.

1.While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Note that non-docking iPods will NOT charge.