10. Refer to Figure 18.
4 3 2 1
Off
On
| Figure 18. Switch Card Assembly Internal Switches |
|
|
|
|
|
|
|
|
| |||||||||
11. Each disk drive module is identified to the using system by a SCSI address. | |||||||||||||||||||
| This address is related to the slot in which the disk drive module is installed. | ||||||||||||||||||
| The SCSI address switch 1 must always be set to the Off position. |
|
|
| |||||||||||||||
| Table 1 shows the SCSI addresses of the disk drive module slots. |
|
|
|
| ||||||||||||||
| Note: On the 2104 Model DU3, the physical numbers of the disk drive |
| |||||||||||||||||
|
| module slots are always 1 through 14, from left to right. |
|
|
|
| |||||||||||||
| Table 1. SCSI Addresses of Disk Drive Module Slots |
|
|
|
|
|
|
|
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Disk drive |
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 |
| 12 | 13 |
| 14 | |
| module slot |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| SCSI |
| 0 | 1 | 2 | 3 | 4 | 5 | 6 | 8 | 9 | 10 | 11 |
| 12 | 13 |
| 14 | |
| address |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Note: If the 2104 is configured for single SCSI bus mode with two SCSI |
| |||||||||||||||||
|
| ||||||||||||||||||
|
| attachments (for example, SCSI adapters), SCSI addresses 5 and 6 |
| ||||||||||||||||
|
| cannot be used. The disk drive module slots with SCSI addresses 5 and | |||||||||||||||||
|
| 6 (disk drive module slots 6 and 7) must contain dummy disk drive |
| ||||||||||||||||
|
| modules. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
| The SCSI enclosure services (SES) use address 15 if the Enable Enclosure | ||||||||||||||||||
| Services switch is set to On. |
|
|
|
|
|
|
|
|
|
|
|
|
242104 Model DU3 Installation Guide