GE MG13400, MG19400, MG20100 manual Adjusting the volume, Customizing the picture, Using Mute

Page 20

TV OPERATION

Adjusting the volume

Raising or lowering the volume

To raise or lower the TV’s volume:

1Press VOL+ to raise the volume or –VOLto lower the volume.

Using Mute

At any time, you can mute (silence) the volume.

1Press the MUTE button and the volume will be silenced.

The word “Mute” appears in the lower-left corner of the screen.

22 To turn mute off, press MUTE again, or simply raise or lower the volume with the –VOLand VOL+ buttons.

Customizing the picture

You can use the on-screen menus to change the contrast, brightness, sharpness, color, and tint on your TV. To customize your picture:

1Press MENU. You will see the open Video menu.

Video Settings Standard

Time

Setup

22 Press –VOLor VOL+ until the word “Custom” appears.

Video	Settings Custom
	Contrast
	Bright
Time	Sharpness
	Color
	Tint

Setup

33 Press CH ▼ to select the item you wish to change

Video	Settings
	Contrast
	Bright
Time	Sharpness
	Color
	Tint

Setup

16CHAPTER THREE: TV OPERATION

Image 20

Contents TV User’s Guide Important Safety Instructions Important Safety InformationPower Consumption 100-240V~50-60 Hz Important Safety InstructionsImportant Safety Instructions Iii. Important Safety Instructions Contents Contents List of features Chapter ONEYour NEW TV Checking partsFront panel jacks, buttons and indicators Rear panel Learning about your new TVVideo and Audio input jacks Use these jacks to connect a VCR or other video equipmentRemote control Number buttons+100 STDAntennas with 300-ohm flat twin leads Chapter TWO InstallationConnecting VHF and UHF antennas Installation Antennas with 75-ohm round leadsSeparate VHF and UHF antennas Cable without a Converter BoxConnecting a VCR Unplug the cable or antenna from the back of the TVConnect a coaxial cable to the VCR’s Antenna OUT terminal Connect an audio cable to the VCR’s Audio OUT terminalConnecting a camcorder Installing batteries in the remote controlLocate the camcorder’s A/V output jacks on the camcorder Connect a video cable to the camcorder’s Video OUT terminalWith the TV’s power on, press the Menu button Chapter Three TV OperationTurning the TV on/off Viewing the menusTV Operation Selecting the menu languagePress CH until Language is highlighted Press Display to exit the menusMemorizing the channels Storing channels in memoryAdding and Erasing Channels Press Menu twice to clear the screenPress Display or Menu to clear the menus from the screen Fine tuning channelsMemorizing channels Using the channel buttons Directly accessing channelsChanging channels Scanning the channelsSetting the clock Press VOL +Adjusting the volume Raising or lowering the volumeUsing Mute Customizing the pictureUsing Automatic Picture VOLlowers brightnessSetting the sleep timer Viewing the on-screen displaysViewing a VCR or camcorder tape To return to normal TV viewing, press TV/VIDEO againChapter Four Special Features Setting the On/Off TimerPress VOL+ to set the timer to on Press CH to highlight On time. Press VOL +When you are finished setting the timer, press Display Special FeaturesUsing the Skip Timer Press VOL+ to open the Closed Caption menu Viewing Closed CaptionsPress VOL + to turn closed captioning on Appendix TroubleshootingIdentifying Problems Appendix Cleaning and maintaining your TVSpecifications Page Page Page