GE MG13400, MG19400, MG20100 manual Special Features, Using the Skip Timer

Page 24

SPECIAL FEATURES

Setting the On/Off Timer, continued

Using the SKIP TIMER

55 Press VOL +. Press CH ▲ or CH ▼ to select the minutes when you want the TV to turn on.

Video

Clock

Time Timer

On time 11:30am

Off time

Setup

66 When you are finished, press VOL +.

77 If you want to set the Off time, press CH ▼ to highlight “Off time.” Set the “Off time” just as you set the “On time.”

Video

 

Clock

 

Time

Timer

 

 

On time

 

Setup

Off time

12:00am

 

 

88 When you are finished setting the timer, press DISPLAY.

This feature allows you to set the TV to return to a particular channel after a certain amount of time. For example, you may be watching a channel when commercials start. You can set the SKIP TIMER to “2 minutes,” then switch channels. After 2 minutes, the TV will return to the original channel. To use the SKIP TIMER:

1While you are watching the channel to which you want to return, press SKIP TIMER.

The on-screen display will read “Skip off.”

2Press SKIP TIMER again to set the timer in thirty second intervals, up to five minutes.

The time you set will begin counting down on the screen. When the time runs out, the TV will return to the channel you were watching when you set the timer.

Skip 1:30

20CHAPTER FOUR: SPECIAL FEATURES

Image 24
Contents TV User’s Guide Important Safety Instructions Important Safety InformationPower Consumption 100-240V~50-60 Hz Important Safety InstructionsImportant Safety Instructions Iii. Important Safety Instructions Contents Contents List of features Chapter ONEYour NEW TV Checking partsFront panel jacks, buttons and indicators Rear panel Learning about your new TVVideo and Audio input jacks Use these jacks to connect a VCR or other video equipmentRemote control Number buttons+100 STDChapter TWO Installation Connecting VHF and UHF antennasAntennas with 300-ohm flat twin leads Installation Antennas with 75-ohm round leadsSeparate VHF and UHF antennas Cable without a Converter BoxConnecting a VCR Unplug the cable or antenna from the back of the TVConnect a coaxial cable to the VCR’s Antenna OUT terminal Connect an audio cable to the VCR’s Audio OUT terminalConnecting a camcorder Installing batteries in the remote controlLocate the camcorder’s A/V output jacks on the camcorder Connect a video cable to the camcorder’s Video OUT terminalWith the TV’s power on, press the Menu button Chapter Three TV OperationTurning the TV on/off Viewing the menusTV Operation Selecting the menu languagePress CH until Language is highlighted Press Display to exit the menusMemorizing the channels Storing channels in memoryAdding and Erasing Channels Press Menu twice to clear the screenFine tuning channels Memorizing channelsPress Display or Menu to clear the menus from the screen Using the channel buttons Directly accessing channelsChanging channels Scanning the channelsSetting the clock Press VOL +Adjusting the volume Raising or lowering the volumeUsing Mute Customizing the pictureUsing Automatic Picture VOLlowers brightnessSetting the sleep timer Viewing the on-screen displaysViewing a VCR or camcorder tape To return to normal TV viewing, press TV/VIDEO againChapter Four Special Features Setting the On/Off TimerPress VOL+ to set the timer to on Press CH to highlight On time. Press VOL +Special Features Using the Skip TimerWhen you are finished setting the timer, press Display Viewing Closed Captions Press VOL + to turn closed captioning onPress VOL+ to open the Closed Caption menu Troubleshooting Identifying ProblemsAppendix Cleaning and maintaining your TV SpecificationsAppendix Page Page Page